Algo Page

The Algo page contains the editor for the FM algorithm. Here, you can freely connect the eight available operators. You can emulate the classic DX7 and modern FMX algorithms, for example, but you can also create our own complex algorithms.

On the right, the eight operators are shown in a diagonal line. Lines that connect operators above the diagonal line indicate feedback connections. Lines below the diagonal line indicate the modulations. At the bottom of the tab, two rows contain the Output Level and Pan controls for the carrier operators.

To select a new algorithm preset, click Select Preset above the display.
To select an operator, click on it in the display.
To edit an operator, double-click it.

This opens the Level page for the operator.
To activate/deactivate an operator, hold down Shift, and click an operator.
To solo an operator, hold down Ctrl/Cmd, and click it or right-click it. If the operator is part of a chain, that is, if other modulators are connected directly or via a feedback connection, the entire chain is soloed.

To select a new algorithm preset, click Select Preset above the display.
To select an operator, click on it in the display.
To activate/deactivate an operator, hold down Shift, and click an operator.
To solo an operator, hold down Ctrl/Cmd, and click it or right-click it. If the operator is part of a chain, that is, if other modulators are connected directly or via a feedback connection, the entire chain is soloed.