Merging pedal lines

You can merge existing sustain pedal lines together; for example, if you want to fill in a gap between two sustain pedal lines.

Note

These steps only apply to sustain pedal lines.

Prerequisite

If you are in Engrave mode, Graphic Editing Graphic Editing button is selected in the Engrave toolbox.

Procedure

  1. Select the sustain pedal lines on the same staff that you want to merge together. You can do this in Write mode and Engrave mode.
    Note

    You can only merge pedal lines on one staff at a time.

  2. Choose Edit > Notations > Pedal Lines > Merge Pedal Lines. You can also choose this option from the context menu.

Result

The selected pedal lines are merged together into a single pedal line. If there were gaps between them, a continuation line is automatically shown across them.

Example

Figure 1. Two separate pedal lines
Figure 2. Two pedal lines merged into one

After Completing This Task

You can input retakes and pedal level changes; for example, if you want to show a retake at the position where previously one of the pedal lines started.