Changing the gap before codas
You can change the default gap preceding all coda sections project-wide.
Procedure
- Press Ctrl/Cmd-Shift-E to open Engraving Options.
- In the category list, click Repeat Markers.
- In the Repeat Sections section, change the value for Default gap before mid-system coda section.
- Click Apply, then Close.
Result
The gap preceding all coda sections project-wide is changed. Dorico Pro uses the same gap size before the start of codas whether they occur partway through systems or at the start of a new system.
Note
You cannot move the start of systems that start with codas further to the left than the gap set for Default gap before mid-system coda section.