Conditions

Depending on the Filter Target setting, the following options can be selected in the Condition column:

Equal

…has the exact same value as set up in the Parameter 1 column.

Unequal

…has any value other than the one set up in the Parameter 1 column.

Bigger

…has a value higher than the one set up in the Parameter 1 column.

Bigger or Equal

…has a value that is the same as or higher than the one set up in the Parameter 1 column.

Less

…has a value lower than the one set up in the Parameter 1 column.

Less or Equal

…has a value that is the same as or lower than the one set up in the Parameter 1 column.

Inside Range

…has a value that is between the values set up in the Parameter 1 and Parameter 2 columns. Note that Parameter 1 should be the lower value and Parameter 2 the higher.

Outside Range

…has a value that is not between the values set up in the Parameter 1 and Parameter 2 columns.

Inside Bar Range (Logical Editor only)

…is within the “zone” set up in the Bar Range/Time Base column (Position only), in each bar within the current selection.

Outside Bar Range (Logical Editor only)

…is outside the “zone” set up in the Bar Range/Time Base column (Position only), in each bar within the current selection.

Before Cursor (Logical Editor only)

…is before the song cursor position (Position only).

Beyond Cursor (Logical Editor only)

…is after the song cursor position (Position only).

Inside Track Loop (Logical Editor only)

…is inside the set track loop (Position only).

Inside Cycle (Logical Editor only)

…is inside the set cycle (Position only).

Exactly matching Cycle (Logical Editor only)

…exactly matches the set cycle (Position only).

Note is equal to

…is the note specified in the Parameter 1 column, regardless of octave (Pitch only). For example, lets you find all C notes, in all octaves.

Below, the different Filter Targets (and their corresponding Condition and Parameter options) are described in more detail.