Searching for elements at certain positions (Logical Editor only)

Selecting “Position” in the Filter Target column lets you find elements starting at certain positions, either relative to the start of the song or within each bar.

• If you select any condition other than the Range or Bar Range options, you set up a specific position (in PPQ, seconds, samples, or frames) in the Parameter 1 column. Use the Bar Range/Time Base column to specify the time base.

  

  Figure: Here, the Logical Editor will find all elements at 1.1.1.0 in the project.

• If you select Inside Range or Outside Range in the Condition column, you set the start position of the range in the Parameter 1 column and the end position in the Parameter 2 column. You can also change the time base using the Bar Range/Time Base column.

  The Logical Editor will then find all elements inside or outside this position range.

• If you select one of the Bar Range options in the Condition column, the Bar Range/Time Base column will show a graphic bar display. You specify the range within the bar by clicking and dragging in the bar display (the specified Bar Range is highlighted).

  The Logical Editor will then find all elements starting inside or outside this Bar Range, in all bars (within the current selection).

  

  Figure: Here, the Logical Editor will find elements starting around the second beat in each bar.