Setting Up the Routing for Individual Mixes

You can define which signals are audible during the different ADR phases, and you can set up different schemes for the dubbing artist and the ADR operator, for example. The routing that you set up is automatically applied when you use the ADR modes. The settings are saved globally.

Procedure

  1. In the ADR section of the Markers/ADR window, click ADR Setup .
  2. In the ADR Setup window, click Signal Switchboard.

    The signal switchboard shows all ADR tracks (sources) for the Control Room (destination) in the upper section and the cues 1 to 4 (destinations) in the lower section.

  3. Activate the checkboxes for the signals that you want to listen to on each ADR track.

    To listen to the source signal of a specific ADR track during pre-roll, activate the Pre option for that track. To listen to the signal during the take, activate Take. To listen to the signal during post-roll, activate Post.

    Note

    In the MixConsole, make sure that the Control Room and the Cue channels are set up correctly.