Replacing Samples
You can replace samples using the Load/Replace Sample button in the header of the Sample Editor.
Furthermore, the Program Tree allows you to exchange samples, for example, to replace the snare drum in a drum loop. This can be done by replacing the sample or the sample zone. If you replace the sample, zone parameters like filter settings, etc. remain unaffected. If you replace the entire zone, the sample and all zone parameters are replaced.
In the Program Tree, drag the new sample or sample zone onto the sample or zone that you want to replace.
Drag the new sample or zone from the Program Tree onto the slice that you want to replace on the Slice tab.
If the replacement sample is longer than the original, change the Playback Mode of the zone to One-Shot, to make sure that the sample is played until the end.
If you replace slices in the Sample Editor, the following applies:
-
Samples that were replaced are shown in a different color.
-
The Sample Editor does not show the waveform of the replaced sample, only the original sample waveform.
If you revert the slicing of a loop, all created zones are deleted and any replacement samples are also discarded.