This plug-in is a single-stage chorus effect. It doubles the audio that is sent into it with a slightly detuned version.


Affects the frequency range of the modulation sweep by adjusting the initial delay time.


Sets the depth of the chorus effect. Higher settings produce a more pronounced effect.


Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.


Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.


Allows you to set the sweep rate freely with the Rate knob.

Waveform Shape

Allows you to select the modulation waveform, altering the character of the chorus sweep. A sine and a triangle waveform are available.

Lo Filter/Hi Filter

Allow you to roll off low and high frequencies of the effect signal.


If side-chaining is supported, the modulation can also be controlled from another signal source via the side-chain input. If the side-chain signal exceeds the threshold, the modulation is controlled by the side-chain signal’s envelope. For a description of how to set up side-chain routing, see the “Operation Manual”.