Changing the appearance of repeat ending segments

You can change the appearance and length of individual repeat ending segments, independently of other segments and your project-wide settings.

Prerequisite

  • The lower zone is shown.

  • Properties is selected in the lower zone toolbar.

  • Graphic Editing Graphic Editing button is selected in the Engrave toolbox.

Procedure

  1. In Engrave mode, select the repeat ending segments whose appearance you want to change.
    Note

    You must select either only final segments or only preceding segments.

  2. In the Properties panel, activate End of line in the Repeat Endings group.
  3. Select one of the following options from the menu:

    • Open, short

    • Open, full length

    • Closed

Result

The appearance of the selected repeat ending segments is changed.

Tip

You can change the default appearance of all repeat ending segments project-wide in Engraving Options > Repeat Endings > Segments.