Logical Editor Filter Conditions

Depending on the Filter Target setting, the following options can be selected in the Condition column:

Equal

Has the same value as set up in the Parameter 1 column.

Unequal

Has any value other than the one set up in the Parameter 1 column.

Bigger

Has a value higher than the one set up in the Parameter 1 column.

Bigger or Equal

Has a value that is the same as or higher than the one set up in the Parameter 1 column.

Less

Has a value lower than the one set up in the Parameter 1 column.

Less or Equal

Has a value that is the same as or lower than the one set up in the Parameter 1 column.

Inside Range

Has a value that is between the values set up in the Parameter 1 and Parameter 2 columns. Parameter 1 should be the lower value and Parameter 2 the higher.

Outside Range

Has a value that is not between the values set up in the Parameter 1 and Parameter 2 columns.

Inside Bar Range

Has a value that is within the zone set up in the Bar Range/Time Base column, in each bar within the current selection. This is only used if the Filter Target is set to Position.

Outside Bar Range

Has a value outside the zone set up in the Bar Range/Time Base column, in each bar within the current selection. This is only used if the Filter Target is set to Position.

Before Cursor

Is before the cursor position. This is only used if the Filter Target is set to Position.

Beyond Cursor

Is after the cursor position Position only.

Inside Cycle

Is inside the set cycle. This is only used if the Filter Target is set to Position.

Outside Cycle

Is outside the set cycle. This is only used if the Filter Target is set to Position.

Inside Track Loop

Is inside the set track loop. This is only used if the Filter Target is set to Position.

Exactly Matching Cycle

Exactly matches the set cycle. This is only used if the Filter Target is set to Position.

Inside Selected Marker

Is inside the selected cycle marker. This is only used if the Filter Target is set to Position.

Note is Equal to

Is the note specified in the Parameter 1 column only, regardless of octave. For example, lets you find all C notes, in all octaves. This is only available if the Filter Target is set to Value 1, that is, Pitch.

All Types

All event types.

Property is Set

The property specified in the Parameter 1 column is set.

Property is Not Set

The property specified in the Parameter 1 column is not set.

Every other Event

Every x event, where x is the value specified in the Parameter 2 column. This is only used if the Filter Target is set to Last Event, and Parameter 1 is set to Event Counter.