Setting up Conditions

By setting up conditions, you can determine which zone is triggered.

Prerequisite

  • You have inserted the MegaTrig module at the position where you want to apply the condition.

    This can be the program or one of its layers. All zones within a program or layer are affected.

  • The MIDI Modules Editor shows the MegaTrig module.

Note

It is possible to set up expressions that cannot be true, such as Note-on AND Note-off, Note-on AND Key up. Be sure to check that your expressions can be true.

Procedure

  1. On the Condition pop-up menu for the first condition row, select an event.

    For example, select Note-Off to trigger new samples when a key is released.

  2. Activate the condition by clicking its On/Off button on the left.
  3. Use the Range controls on the right to adjust the range of the notes that trigger the condition.
  4. Optional: To set up more conditions, repeat these steps for additional rows.
  5. Select the logical operations, AND or OR, from the menu to the left of the conditions. To invert a condition, activate the NOT operation.

    For example, the expression Note-on AND Sustain On is true if you play notes while holding down the sustain pedal.

    Note

    The operation AND is executed before the operation OR.

  6. Use the Trigger option to specify which notes are triggered when the expression becomes true, that is, when the conditions are met.
  7. Optional: Set up the parameters in the Note-off Velocity section.