Deleting bracket and barline changes

You can delete custom changes to bracket/brace grouping and barline joins, for example, if you change your mind about where you want to reset the bracket/brace grouping.

Prerequisite

If you are in Engrave mode, Graphic Editing is selected in the Engrave toolbox.

Procedure

  1. Select the bracket and barline change signposts that you want to delete. You can do this in Write mode and Engrave mode.
  2. Press Backspace or Delete.

Result

The selected bracket and barline changes are deleted. Staff grouping on any corresponding systems follows either the previous bracket and barline change or the project-wide staff grouping settings if there is no previous bracket and barline change.

Tip
  • In Engrave mode, you can also select the brackets/braces you want to delete.

  • You can also delete individual barline joins independently of other barline joins and bracket/brace grouping changes at the same rhythmic position.