Modulation Effects Section

In this section, you can select the modulation effect that you want to use from the Type menu. You can choose between the following effects: Chorus, Flanger, Ensemble, and Phaser.

For Chorus and Flanger, the following parameters are available:

Rate: Specifies the frequency of the pitch modulation.
Sync: Allows you to set the Rate value in fractions of beats.
Depth: Sets the intensity of the pitch modulation.
Phase: Widens the sound image of the effect from mono to stereo.
Feedback: Adds resonances to the effect.
Mix: Sets the ratio between the dry and the wet signal.

For the Ensemble effect, the following parameters are available:

Sync: Allows you to set the Rate value in fractions of beats.
Rate: Sets the frequency of the LFO.
Depth: Sets the intensity of the delay time modulation by the LFO.
Shimmer: Sets the intensity of a secondary faster delay time modulation.
Shimmer Rate: Determines the relation between the speed of the primary and the secondary delay modulation. For example, at a value of 10, the secondary modulation is 10 times faster.
Mix: Sets the ratio between the dry and the wet signal.

For the Phaser effect, the following parameters are available:

Sync: Allows you to set the Rate value in fractions of beats.
Rate: Specifies the frequency of the phase modulation.
Phase: Widens the sound image of the effect from mono to stereo.
Depth: Sets the intensity of the phase modulation.
Feedback: Adds resonances to the effect. Higher settings produce a more pronounced effect.
Shift: Shifts the phase modulation upwards to higher frequencies of the spectrum.
Low Cut: Attenuates the low frequencies.
High Cut: Attenuates the high frequencies.
Mix: Sets the ratio between the dry and the wet signal.