Transport

• To activate the Transport, click Set up Window Layout on the Project window toolbar and activate Transport.

  

• To show/hide tools, open the Transport context menu by right-clicking in an empty area of the Transport and activate the tools that you want to display. To show all tools, select Show All.

The following options are available:

Constrain Delay Compensation

Allows you to minimize the latency effects of the delay compensation.

Common Record Modes

Allow you to determine what happens if you click Record during an audio or MIDI recording.

Audio Record Modes

Allow you to select what happens when you record over existing audio events.

MIDI Record Modes

Allow you to select what happens when you record over existing MIDI parts.

Left Divider

Allows you to use the left divider. Tools that are placed to the left of the divider are always shown.

System Performance Meter

Shows the meters for ASIO time usage and hard disk transfer load.

Locators

Allows you to go to the left or right locator position, and to set the left and right locator position numerically.

Punch Points

Allows you to activate/deactivate Punch In and Punch Out. These points determine the record start and stop positions.

The section to the right of the punch buttons allows you to set up the punch positions numerically. For this to work, Lock Punch Points to Locators must be deactivated. You can hide/show that section by clicking the points on the divider.

Main Transport

Shows the main transport controls.

Time Displays

Shows the time display options.

Pre-roll & Post-roll

Allows you to activate/deactivate pre-roll and post-roll, and to set the values numerically.

Tempo & Time Signature

Allows you to activate/deactivate the tempo track, and to set the tempo value and the first time signature value numerically.

External Sync State

Allows you to activate/deactivate external synchronization and to open the Project Synchronization Setup dialog.

Click & Count-In & Click Pattern

Allows you to activate/deactivate the metronome click, the metronome click in count-in, and the click pattern.

Right Divider

Allows you to use the right divider. Tools that are placed to the right of the divider are always shown.

Input/Output Activity

Allows you to monitor the MIDI input/output signals, the audio input/output signals, and allows you to control the output level.