Selecting graphic slice handles

You can select an individual handle on a graphic slice, and you can switch between having a handle selected and having the whole graphic slice selected.

Prerequisite

Graphic Slices Graphic Slices button is selected in the Engrave toolbox.

Procedure

  1. Select a graphic slice handle in any of the following ways:
    • Select any handle on the graphic slice and press Right Arrow/Left Arrow/Up Arrow/Down Arrow to select other handles around its edge.

    • Select the graphic slice, press Tab to switch to having the handle in the top left corner selected, then press Right Arrow/Left Arrow/Up Arrow/Down Arrow to select other handles around the edge of the graphic slice.

    • Click a handle on the graphic slice.

    Note

    You can only select a single handle on a single graphic slice at a time.

  2. Optional: To switch back to having the whole graphic slice selected, press Tab.

Example

Figure 1. Whole graphic slice selected
Figure 2. Graphic slice with top middle handle selected