Track Control Area for Reference Tracks
The track control area for reference tracks allows you, for example, to listen to the reference track, specify routing options, and monitor the input signal.
- Track Name
-
Allows you to change the track name. Double-click the track name to open the Track Name dialog where you can enter a name for the track.
- Lock
-
Disables all editing on the track.
- Listen Alone
-
Allows you to enable the reference track while muting all other tracks.
- Monitor
-
Allows you to monitor the input signal.
- Routing
-
Allows you to select the buses for routing.
- Change Track Height of All Tracks
-
The lower left area of each track control area allows you to change the track height of all tracks simultaneously. Click and drag to change the track height.
- Change Track Height of Selected Track
-
The lower middle area of each track control area allows you to change the track height of the selected track. Click and drag to change the track height.
- Change Track Height of Selected Track and Track Below
-
The lower right area of each track control area allows you to change the track height of the selected track and the track below. Click and drag to change the track height.
Track Pop-up Menu
This pop-up menu contains all track-related options.
-
To open the Track pop-up menu, right-click in the track control area.
- Track Color
-
Opens a submenu where you can select a color for the active track.
- Zoom In
-
Shows the active track in the full available height.
- Zoom Out
-
Shows as many tracks as possible.
- Add Track
-
Allows you to add a track below the active track.
- Duplicate Track
-
Creates a copy of the active track. The duplicate is added below the active track.
- Copy Clips to Track
-
Allows you to copy all selected clips from the selected track to the focused track.
- Remove Track
-
Deletes the active track.
- Move Track Up/Move Track Down
-
Moves the selected track up or down.
- Routing
-
Allows you to select the buses for routing.
The following output bus options are available:
-
If Main Playback Bus is activated, the track audio is sent to this bus.
-
If Master Section Playback Processing is activated, the track audio is sent to this bus.
-
If you have defined Additional Output Buses, you can send the track audio to these buses.
The following input bus options are available:
-
If Main Recording Bus is activated, the main recording bus is used as input bus.
-
If Direct Monitoring is activated, the audio signal does not go through the montage. This allows you to monitor the audio without latency.
-