Quick Control Assignments Editor

The Quick Control Assignments editor lists the eight quick controls for the selected program or layer on the left. The assignments of the selected quick control are listed on the right. You can edit the parameters for each assignment separately.

  • To open the Quick Control Assignments editor, right-click a quick control and select Edit Quick Control, or open the Edit page for a program and select the QC tab in the lower part of the page.

Quick Control Parameter

Displays the parameter assignment for the selected quick control.

Affected Layers/Modules

Displays which program, layer, or module is affected by the quick control.

Bypass Single Quick Control Assignment

Bypasses the corresponding quick control assignment.

For example, if a quick control is assigned to several layers, this option allows you to bypass the quick control assignment for only one layer).

Mode

Determines the mode that is used for changing the parameter values.

  • Absolute remote-controls the parameter values continuously. Absolute mode changes the assigned parameters by overwriting them with the current quick control value, that is, parameter changes are overwritten.

  • Relative remote-controls the parameter values continuously. Relative mode changes the values of the assigned parameters without losing their relative settings, that is, parameter changes are still audible.

  • Switch Absolute switches between the minimum and maximum value. Parameter changes are overwritten.

  • Switch Relative switches between the minimum and maximum value. Parameter changes are still audible.

Minimum Value

Sets the minimum value for the quick control assignment.

Curvature

Sets the curvature. You can also set the curvature by clicking and dragging in the curve display.

Maximum Value

Sets the maximum value for the quick control assignment.

Bypass All Quick Control Assignments

Bypasses all assignments for the selected quick control.