Changing the caps of lines
You can change the caps of individual lines without changing their body style.
Prerequisite
-
The lower zone is shown.
-
Properties is selected in the lower zone toolbar.
Procedure
-
Select the lines whose caps you want to change.
Note
You must select either only horizontal lines or only vertical lines.
-
In the Properties panel, activate the following properties, individually or together, in either the Horizontal Lines or Vertical Lines group:
-
To change the cap at the start/bottom of the selected lines, activate Start cap.
-
To change the cap at the end/top of the selected lines, activate End cap.
-
To change the segment start cap of the selected horizontal lines on subsequent systems, activate Continuation cap.
-
To change the segment end cap of the selected horizontal lines on previous systems to where the lines end, activate Continuation end cap.
-
- Select the style you want from each menu.
Result
The corresponding caps of the selected lines are changed.
This does not affect the body style of the selected lines.