Changing the size of dashes/dots in slurs

You can change the length of dashes and the size of dots in dashed/dotted slurs individually, independently of your project-wide settings.
Note

This only applies to dashed/dotted slurs.

Procedure

  1. In Engrave mode, select the dashed/dotted slurs whose dash length/dot size you want to change.
  2. In the Properties panel, activate one of the following properties in the Slurs group:

    • For dashed slurs, activate Dash length.

    • For dotted slurs, activate Dot size.

  3. Change the value in the value field.

Result

Increasing the value makes dashes longer and dots bigger, decreasing the value makes dashes shorter and dots smaller.

Tip

You can find options to set the default size of dashes/dots in all dashed/dotted slurs project-wide by clicking Advanced Options in the Design section of the Slurs page in Engrave > Engraving Options.