StereoDelay

StereoDelay has two independent delay lines which either use tempo-based or freely specified delay time settings.

Note

This plug-in works only on stereo tracks.

Feedback

Set the number of repeats for each delay.

Delay

Sets the delay time in milliseconds.

Sync

Activates/Deactivates tempo sync for the corresponding delay.

Mix

Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.

Lo Filter

Affects the feedback loop of the effect signal and allows you to roll off low frequencies. The button below the control activates/deactivates the filter.

Pan

Sets the stereo position.

Hi Filter

Affects the feedback loop of the effect signal and allows you to roll off high frequencies. The button below the control activates/deactivates the filter.

Note

This plug-in supports external side-chaining. You can use the side-chain input to control the delay from another signal source. If the side-chain signal exceeds the threshold, the delay repeats are silenced. If the signal drops below the threshold, the delay repeats reappear. For a description of how to set up side-chain routing, see the Operation Manual.