Phaser
Phaser produces the well-known swooshing phasing effect with additional stereo enhancement.
Cubase LE |
Cubase AI |
Cubase Elements |
Cubase Artist |
Cubase Pro |
Nuendo |
|
---|---|---|---|---|---|---|
Included with |
X |
X |
X |
X |
X |
X |
Side-chain support |
– |
– |
– |
X |
X |
X |
- Feedback
-
Determines the character of the phaser effect. Higher settings produce a more pronounced effect.
- Width
-
Sets the intensity of the modulation effect between higher and lower frequencies.
- Mode
-
Allows you to toggle between LFO and Manual mode.
In LFO mode, you can define the sweep rate or sync it to the project tempo. In Manual mode, you can change the sweep manually.
- Rate
-
If Sync is activated, Rate allows you specify the base note value for tempo-syncing the phaser sweep (1/1 to 1/32, straight, triplet, or dotted).
If Sync is deactivated, the sweep rate can be set freely with the Rate knob.
- Sync
Activates/Deactivates tempo sync.
- Spatial
If you are using multi-channel audio, the Spatial parameter creates a 3-dimensional impression by delaying modulation in each channel.
- Mix
Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value as you can control the dry/effect balance with the send.
- Lo Filter/Hi Filter
Allow you to roll off low and high frequencies of the effect signal.
If side-chaining is supported, the modulation can also be controlled from another signal source via the side-chain input. If the side-chain signal exceeds the threshold, the modulation is controlled by the side-chain signal’s envelope. For a description of how to set up side-chain routing, see the “Operation Manual”.