Chorus
This plug-in is a single-stage chorus effect. It works by doubling the audio that is sent into it with a slightly detuned version.
|
Cubase LE |
Cubase AI |
Cubase Elements |
Cubase Artist |
Cubase Pro |
Nuendo |
|
|---|---|---|---|---|---|---|
|
Included with |
X |
X |
X |
X |
X |
X |
|
Side-chain support |
– |
– |
– |
X |
X |
X |
- Delay
Affects the frequency range of the modulation sweep by adjusting the initial delay time.
- Width
Sets the depth of the chorus effect. Higher settings produce a more pronounced effect.
- Spatial
Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.
- Mix
Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value as you can control the dry/effect balance with the send.
- Rate
-
If Sync is activated, Rate allows you to specify the base note value for synchronizing the modulation sweep to the tempo of the host application (1/1 to 1/32, straight, triplet, or dotted).
If Sync is deactivated, the sweep rate can be set freely with the Rate knob.
- Sync
Activates/Deactivates tempo sync.
- Waveform Shape
Allows you to select the modulation waveform, altering the character of the chorus sweep. A sine and a triangle waveform are available.
- Lo Filter/Hi Filter
Allow you to roll off low and high frequencies of the effect signal.
If side-chaining is supported, the modulation can also be controlled from another signal source via the side-chain input. If the side-chain signal exceeds the threshold, the modulation is controlled by the side-chain signal’s envelope. For a description of how to set up side-chain routing, see the “Operation Manual”.