Advanced Options
The advanced options can be opened using the top left button in the main plug-in panel. These options can be set for the plug-in instance by adjusting the values as needed.
Distance Dependent Parameters
- Loudness
Allows you to select whether the volume change that is to be applied depends on the position of the center point, or if the volume change is calculated for each input channel separately.
Sets the maximum gain reduction that is applied if the group input or channel reaches the stage border.
- EQ Gain
Allows you to select whether the filtering that is to be applied depends on the position of the center point, or if the amount of filtering is calculated for each input channel separately.
Sets the maximum gain reduction of the filter that is applied if the group or input channel reaches the stage border.
- EQ Cutoff
Sets the cutoff frequency of the distance-dependent EQ.
Upmix – Matrix
Activates matrix decoding for matrix-encoded input signals.
Matrix decoding is only applied in upmix mode.
LFE Parameters
- LFE Gain
Sets a separate gain level for the LFE channel that is applied to the plug-in output.
- LP Enable
Enables a low-pass filter that is applied to the LFE output channel after summing the signals from the input channels.
- LP Cutoff
Sets the cutoff frequency for the generated LFE channel.
- LP Order
Allows you to select the order, or slope, of the low-pass filter.
2nd order = 12 dB/octave
3rd order = 18 dB/octave
4th order = 24 dB/octave
The amount of LFE can be adjusted for each input channel individually.
If the selected input configuration includes an LFE channel, but the selected output configuration does not, the LFE input channel is distributed to front left and front right at a level of -3 dB automatically. The low-pass filter is applied to the incoming LFE signal before it is distributed to the front speakers.