RingModulator

RingModulator can produce complex, bell-like enharmonic sounds.

Ring modulators work by multiplying two audio signals. The ring-modulated output contains added frequencies generated by the sum of, and the difference between, the frequencies of the two signals.

RingModulator has a built-in oscillator that is multiplied with the input signal to produce the effect.

Oscillator

Waveform buttons

Allow you to select the oscillator waveform: square, sine, saw, or triangle.

LFO Amount

Controls how much the LFO affects the oscillator frequency.

Env. Amount

Controls how much the oscillator frequency is affected by the envelope that is triggered by the input signal. Left of center, a loud input signal decreases the oscillator pitch, whereas right of center the oscillator pitch increases if it is fed a loud input.

Frequency

Sets the oscillator frequency ± 2 octaves within the selected range.

Roll-Off

Attenuates high frequencies in the oscillator waveform to soften the overall sound. This is best used with harmonically rich waveforms, for example, square or saw.

Range

Determines the frequency range of the oscillator in Hz.

LFO

Waveform buttons

Allow you to select the LFO waveform: square, sine, saw, or triangle.

Speed

Sets the LFO speed.

Env. Amount

Controls how much the input signal level – via the envelope generator – affects the LFO speed. With negative values, a loud input signal slows down the LFO, whereas positive values speed it up at loud input signals.

Invert

Inverts the LFO waveform for the right channel of the oscillator, which produces a wider stereo effect for the modulation.

Envelope Generator

The envelope generator parameters control how the input signal is converted to envelope data, which can then be used to control oscillator pitch and LFO speed.

Attack

Controls how fast the envelope output level rises in response to a rising input signal.

Decay

Controls how fast the envelope output level falls in response to a falling input signal.

Lock R>L

If this button is activated, the L and R input signals are merged, and produce the same envelope output level for both oscillator channels. If the button is deactivated, each channel has its own envelope that affects the two channels of the oscillator independently.

Level Settings

Mix

Sets the level balance between dry and wet signal.

Output

Sets the output level.