Main Layout

Module Chain

The module chain contains the mastering modules. You can add up to 5 modules.

The following settings are available for each module:

Bypass

Bypasses the module. This allows you to compare the sound of the unprocessed signal to that of the processed signal.

Solo

Solos the module. Only one module can be soloed at a time.

Remove

Removes the module from the module chain.

Spectrum Display

The spectrum display in the upper half of the panel is where you set the width of the frequency bands. The vertical value scale to the left shows the gain level of each frequency band. The horizontal scale shows the frequency range.

  • To define the frequency range of the different frequency bands, use the handles at the sides of each frequency band.

  • To attenuate or boost the output level of each frequency band by ±15 dB, use the handles on top of each frequency band.

Settings

Parameter Linking

Links the parameters of the same type in all bands in a module. This allows you to edit parameter values of all bands in a module simultaneously. Two link modes are available: Absolute and Relative.

  • If Absolute Mode is activated and you edit a parameter value in one band, the corresponding parameter values in the other bands are set to the same value.

  • If Relative Mode is activated and you edit a parameter value in one band, the corresponding parameter values in the other bands keep their relation.

Auto Listen for Filters

If this option is activated and you edit a parameter of a module, the corresponding filter or band is soloed. This allows you to locate unwanted frequencies in your audio and helps you to focus on a particular band or filter. Once you stop editing the parameter, Solo is deactivated.

Undo/Redo

Undoes/Redoes the last operation.

Input/Output Meter

The input/output meter provides a combined peak level, with peak-hold functionality and RMS meter. Between the meters for input and output is the gain reduction meter for the Limiter.

The maximum values for input/output peak level, RMS, and gain reduction are displayed above the meter display. To reset all maximum values, click any of the values.