Adding Markers at Video Cut Positions

You can analyze video for cuts between different shots and add position or cycle markers at the detected cut positions.

Prerequisite

  • Your project contains a video file.

Procedure

  1. In the Project window, select the whole video event or a range selection.
  2. Select Project > Video Cut Detection Panel.
  3. On the Video Cut Detection Panel, click Analyze Video.

    The video is analyzed for cuts between shots. When the analyzing process is finished, the detection result is shown in the Number of Video Cuts field and in the Analysis Result section.

  4. Inspect the detected results.
  5. Optional: Adjust the Sensitivity value according to the requirements of the video material.
    Note

    When adjusting Sensitivity, the detection result is instantly updated. You do not need to click Analyze Video again.

  6. Change the settings in the Marker Settings and in the Add Markers section as required.
  7. Click Add Markers.

Result

Position markers or cycle markers are added at all detected cut positions.