ADR Panel

The ADR Panel is located in the lower part of the Markers window.

  • To open the ADR Panel, select Project > ADR Panel.

  1. Locate Previous/Next Marker in Markers Window

    Allows you to select the previous/next marker in the marker list. If Cycle follows when locating to Markers is activated in the Marker Settings, the corresponding locator range is also selected in the Project window ruler.

  2. Pre-Roll On/Off

    Allows you to activate/deactivate a pre-roll for the Free Run Mode.

  3. Free Run Mode On/Off

    Activate this mode to start from the project cursor position. On stop, the cursor returns to the start position by default. You can change this by deactivating Return to Start Position on Stop in the Preferences dialog (Transport page).

    Deactivate this mode to use the selected cycle marker. Pre-roll and post-roll are determined by the settings on the General tab in the ADR Setup window.

  4. Rehearse

    Plays back the selected take so that the artist can rehearse it.

  5. Record

    Records the selected take on the record-enabled track.

  6. Review

    Plays back the take for review. To enable this, on the Signal Switchboard tab, activate Take in Review mode for Other Audio for the Control Room and Cue 1.

  7. Guide Track for Cue 1 On/Off

    Allows you to mute the guide track for cue 1.

  8. Guide Track for Control Room On/Off

    Allows you to mute the guide track for the Control Room.

  9. Setup

    Allows you to open the ADR Setup window.

  10. Show Details View

    Allows you to show/hide the details view.

  11. Show ADR Panel

    Allows you to show/hide the ADR Panel.

  12. Marker Settings

    Allows you to show the marker settings.