Magneto II
This channel strip module simulates the saturation and compression of recording on analog tape machines.
- Saturation
-
Determines the amount of saturation and the generation of overtones. This leads to a small increase in input gain.
- Low-Frequency
-
Sets the frequency range of the spectrum band to which the tape effect is applied.
To avoid the saturation of lower frequencies, set the value to 200 Hz or 300 Hz.
- HF-Adjust
-
Sets the amount of high frequency content of the saturated signal.
- High-Frequency
-
Sets the frequency range of the spectrum band to which the tape effect is applied.
To avoid the saturation of very high frequencies, set this parameter to values below 10 kHz.
- HF-Adjust On/Off
-
Activates/Deactivates the HF-Adjust filter.
- Solo
-
Allows you to hear only the set frequency range including the tape simulation effect. This helps you to determine the appropriate frequency range.
- Output
-
Allows you to adjust the output level.
- Saturation Amount LED
-
Indicates the amount of saturation of the signal.