Replacing Samples

When you replace a sample, HALion tries to maintain the marker positions. However, if the new sample is shorter, any markers that would end up in an area beyond the new sample are set to the end of the sample instead.

To replace a sample, you can do one of the following:

Choices

  • Drag a sample from the browser onto the sample display.

    This replaces all waves for which markers are visible in the sample display. If other waves of the same sample are used in other wave sequences, these waves are not replaced.

  • Drag a sample from the browser onto a selection of multiple waves in the wavetable.

    This replaces the selected waves.

  • Drag a sample from the browser onto a single wave that is not part of a multi-selection of waves.

    This replaces only the wave on which you drop the sample.

  • Click Replace Sample on the wavetable toolbar.

    This replaces all waves for which markers are visible in the sample display. If other waves of the same sample are used in other wave sequences, these waves are not replaced.