Vintage Ensemble

This effect emulates the sound of classic ensemble modulation effects. It is based on a delay with LFO-modulated delay times. A secondary LFO with higher frequencies is used to produce the so-called shimmer.

Rate

Sets the frequency of the LFO.

Sync

If Sync is activated, you can set the Rate value in fractions of beats.

Depth

Sets the intensity of the delay time modulation by the LFO.

Shimmer

Sets the intensity of a secondary faster delay time modulation.

Shimmer Rate

Determines the relation between the speed of the primary and the secondary delay modulation. For example, with a value of 10, the secondary modulation is 10 times faster.

Low Cut

Applies a low-cut filter to the signal. Only frequencies above the set frequency are sent to the effect.

High Cut

Applies a high-cut filter to the signal. Only frequencies below the set frequency are sent to the effect.

FX Level

Allows you to adapt the effect signal level to compensate for level reductions caused by the low-cut and high-cut filters.

Mix

Sets the ratio between the dry and the wet signal.