Vintage Ensemble
This effect emulates the sound of classic ensemble modulation effects. It is based on a delay with LFO-modulated delay times. A secondary LFO with higher frequencies is used to produce the so-called shimmer.
- Rate
-
Sets the frequency of the LFO.
- Sync
-
Allows you to set the Rate value in fractions of beats.
- Depth
-
Sets the intensity of the delay time modulation by the LFO.
- Shimmer
-
Sets the intensity of a secondary faster delay time modulation.
- Shimmer Rate
-
Determines the relation between the speed of the primary and the secondary delay modulation. For example, at a value of 10, the secondary modulation is 10 times faster.
- Low Cut
-
Applies a low-cut filter to the signal. Only frequencies above the set frequency are sent to the effect.
- High Cut
-
Applies a high-cut filter to the signal. Only frequencies below the set frequency are sent to the effect.
- FX Level
-
Allows you to adapt the effect signal level to compensate for level reductions caused by the low-cut and high-cut filters.
- Mix
-
Sets the ratio between the dry and the wet signal.