Changing the staff-relative placement of slash region counts

You can show the counts on individual slash regions either above or below the staff, independently of your project-wide setting.
Note

Changing the staff-relative placement of slash region counts affects all counts on the region. You cannot change the placement of a single count independently of other counts on the same slash region.

Procedure

  1. Select any part of each slash region whose count staff-relative placement you want to change.
  2. In the Properties panel, activate Count position in the Slash Regions group.
  3. Choose one of the following options:
    • Above

    • Below

Result

The staff-relative placement of all counts on the selected slash regions is changed.

Tip

You can change the default placement of all slash region counts project-wide in the Rhythmic slashes section of the Notes page in Engrave > Engraving Options.