Changing the appearance of individual final repeat ending segments

You can change the appearance of the line ends in the final segments of individual repeat endings, independently of your project-wide settings.

Procedure

  1. Select the repeat endings whose final segment appearance you want to change. You can do this in Write mode and Engrave mode.
    Note

    In Engrave mode, you can select any segment in the repeat ending.

  2. In the Properties panel, activate End of line in the Repeat Endings group.
  3. Select one of the following options from the menu:
    • Open, short

    • Open, full length

    • Closed

Result

The end of the line of the final segment in the selected repeat endings is changed.

Tip

You can change the appearance of final segments in all repeat endings project-wide in the Segments section of the Repeat Endings page in Engrave > Engraving Options.