Creating custom beat groupings for meters
If your music requires a different beat grouping for a particular meter than the default setting for that time signature, you can specify your preferred beat grouping within the time signature. You can choose whether or not the time signature shows this custom beat grouping.
The duration of beam groups in Dorico for iPad depends on the beat grouping in the current time signature and your per-flow beam grouping settings in Notation Options. For example, entering [1+1+1+1]/4 into the time signatures popover inputs a time signature with four quarter note (crotchet) groups. Because this creates a time signature with a half-bar, beam grouping options for time signatures with a half-bar apply.
Procedure
-
In Write mode, do one of the following:
-
Start note input.
-
Select an item at the rhythmic position where you want to input a time signature with custom beat grouping.
-
-
Optional: If you want Dorico for iPad to add beats at the end of the region affected by the new time signature if required, activate Insert mode in any of the following ways:
-
Press I.
-
In the Notes toolbox, click Insert .
-
-
Open the time signatures popover in any of the following ways:
-
Press Shift-M.
-
In the Notations toolbox, click Popovers , then Time Signatures (Meter) .
-
-
Enter the division you want in square brackets into the popover.
For example, to divide a 7/8 time signature into 2+3+2, enter [2+3+2]/8 into the popover. To divide a 5/4 time signature into 2+3 rather than 3+2, enter [2+3]/4 into the popover.
- Press Return to close the popover.
Result
The time signature specified is input and beam and beat grouping in subsequent bars follows the division you specified.
You can change the appearance of numerators in individual time signatures so that they show a single number or beat groups.