Changing the appearance of individual final repeat ending segments

You can change the appearance of the line ends in the final segments of individual repeat endings.

Prerequisite

  • The lower zone is shown.

  • Properties is selected in the lower zone toolbar.

Procedure

  1. Select the repeat endings whose final segment appearance you want to change. You can do this in Write mode and Engrave mode.
    Note

    In Engrave mode, you can select any segment in the repeat ending.

  2. In the Properties panel, activate End of line in the Repeat Endings group.
  3. Select one of the following options from the menu:

    • Open, short

    • Open, full length

    • Closed

Result

The end of the line of the final segment in the selected repeat endings is changed.