Adding text to lines

You can add text to both horizontal and vertical lines; for example, to clarify the intention of the line.

Prerequisite

  • The lower zone is shown.

  • Properties is selected in the lower zone toolbar.

Procedure

  1. Select the lines to which you want to add text. You can do this in Write mode and Engrave mode.
    Note

    You must select either only horizontal lines or only vertical lines.

  2. In the Properties panel, activate Text in either the Horizontal Lines or Vertical Lines group.
  3. Enter the text you want into the value field.
  4. Press Return.

Result

The text you entered into the value field is shown centered in the middle of the selected lines. On vertical lines, it reads upwards.

Example

Figure 1. Text on a horizontal line
Figure 2. Text on a vertical line

After Completing This Task

  • If you want text on vertical lines to read downwards, you can reverse the lines.

  • You can erase the backgrounds of text on lines.