Inputting tremolos with the panel

You can input both single-note and multi-note tremolos using the Repeat Structures panel, both during note input and by adding them to existing notes.

Tremolos are included in the Repeat Structures panel because they indicate that notes are repeated, either individually as single-note tremolos or in sequences as multi-note tremolos.


  1. In Write mode, do one of the following:
    • Start note input.


      During note input, you can select additional notes before/after the last input note without deactivating the caret by pressing Shift-Right Arrow/Shift-Left Arrow.

    • Select the notes to which you want to add tremolos.


      If you want to input multi-note tremolos, you must select at least two notes that are in the same voice, have the same duration, and are notated using a single notehead. The notes can also be tuplets and cross-staff notes.

  2. In the Notations toolbox, click Panels Panels button, then Repeat Structures Repeat Structures button to show the Repeat Structures panel.
  3. In the Tremolos section, click the tremolo you want to input.

    For example, click:

    • Two Strokes Single-note Tremolo for single-note tremolos with two strokes.

    • Three Strokes Multi-note Tremolo for multi-note tremolos with three strokes.

    • Tremolo With Release for three-stroke single-note tremolos with release.


Single-note tremolos are input on the selected notes with the number of tremolo strokes specified. They appear on all notes in tie chains.

Tremolos with release show single-note tremolo strokes on all notes in tie chains apart from the last note. Tremolos with attack show single-note tremolo strokes on all notes in tie chains apart from the first note.

Multi-note tremolos with the number of tremolo strokes specified are input between selected individual notes and the notes immediately after them, or between selected pairs of notes. The notated duration of notes in multi-note tremolos is automatically updated. For example, two quarter notes joined by a multi-note tremolo both appear as half notes.

When tuplets are selected, multi-note tremolos are input across the selected tuplets, with the tremolo strokes positioned in the center of all notes in the tuplet. The tuplet bracket is hidden, and a signpost is shown at the start of each tuplet indicating its ratio.


The appearance of stems in multi-note half note tremolos depends on your setting on the Tremolos page in Engraving Options.


Figure 1. Multi-note tremolos with three tremolo strokes across tuplets
Figure 2. Tremolo with release added to tie chain

After Completing This Task

You can enable independent voice playback for individual instruments to hear different sounds in different voices simultaneously; for example, if you have tremolos in one voice and slurs in another voice.