Changing the appearance of individual final repeat ending segments

You can change the appearance of the line ends in the final segments of individual repeat endings, independently of your project-wide settings.


  • The lower zone is shown.

  • Properties is selected in the lower zone toolbar.

  • If you are in Engrave mode, Graphic Editing Graphic Editing button is selected in the Engrave toolbox.


  1. Select the repeat endings whose final segment appearance you want to change. You can do this in Write mode and Engrave mode.

    In Engrave mode, you can select any segment in the repeat ending.

  2. In the Properties panel, activate End of line in the Repeat Endings group.
  3. Select one of the following options from the menu:
    • Open, short

    • Open, full length

    • Closed


The end of the line of the final segment in the selected repeat endings is changed.


You can change the appearance of final segments in all repeat endings project-wide in the Segments section of the Repeat Endings page in Engraving Options.