Hiding/Showing borders on harp pedal diagrams

You can hide/show borders on individual note name harp pedal diagrams, independently of your project-wide setting. For example, on systems with very tight vertical spacing, hiding borders on harp pedal diagrams can give you a little extra space.

Note

These steps only apply to harp pedal diagrams using note names.

Prerequisite

  • Harp pedaling is shown in the current layout.

  • The lower zone is shown.

  • Properties is selected in the lower zone toolbar.

  • If you are in Engrave mode, Graphic Editing Graphic Editing button is selected in the Engrave toolbox.

Procedure

  1. Select the note name harp pedal diagrams on which you want to hide/show borders. You can do this in Write mode and Engrave mode.
  2. In the Properties panel, activate Border in the Harp Pedals group.
  3. Activate/Deactivate the corresponding checkbox.

Result

Borders are shown on the selected note name harp pedal diagrams when the checkbox is activated, and hidden when the checkbox is deactivated.

When the property is deactivated, the selected harp pedal diagrams follow your project-wide setting for hiding/showing borders.

Tip

You can hide/show borders on all note name harp pedal diagrams project-wide in Engraving Options > Harp Pedals > Note Names.

Example

Figure 1. Note name harp pedal diagram with border hidden
Figure 2. Note name harp pedal diagram with border shown