Types of barlines

There are multiple types of barlines in Dorico Pro, which can all be input, moved, and deleted in the same ways.

Normal (Single)

A standard single barline that spans the entire height of the staff. For single-line staves, the barline extends one space above and below the staff line by default.

Double

A double barline consists of two lines, both the width of a single barline, positioned half a space apart by default. It is often used to denote significant changes in the music, or to mark the placement of rehearsal marks, key signature changes, and tempo changes.

Triple

A triple barline consists of three lines, all the width of a single barline, positioned half a space apart by default. It is sometimes used in musicological analysis to demarcate structural units larger than a single bar.

Final

A final barline consists of two lines: one of normal width, the other thick. It marks where the music ends.

Dashed

A dashed barline has the same thickness as a normal barline, but has gaps within it to give it a dashed appearance. It is used to subdivide bars to make complex time signatures easier to read, and to differentiate editorial barlines from ones originally in the manuscript.

Tick

A tick barline is a short line that spans only the top or bottom line of the staff. It is useful when notating plainsong, in which context it denotes a breath or short gap between phrases, or other music with an unusual metrical structure.

Figure 1. Tick (top) barline
Figure 2. Tick (bottom) barline
Short

A short barline spans either the middle of the staff, which on a five-line staff is between the second and fourth lines, or the top half of the staff, which on a five-line staff is between the first and third lines. On staves with fewer than five lines, the short barline is scaled proportionally. It is useful when notating plainsong, in which context it denotes a longer gap between phrases than a tick barline.

Figure 3. Short (center) barline
Figure 4. Short (top) barline
Thick

A thick barline is half a space wide by default, so it is noticeably thicker than a normal barline. This gives it a greater visual impact.

Start repeat

A start repeat line consists of a thick barline, followed by a normal barline, followed by one of the following arrangements of dots:

  • Two dots, one each in the middle two spaces of a five-line staff

  • Four dots, one each in all four spaces of a five-line staff

It shows the start of a repeated section. It is used alongside end repeat lines, which show the end of a repeated section.

End repeat

An end repeat line is the mirror of a start repeat line, so it consists of either two or four dots, followed by a normal barline, followed by a thick barline. It shows the end of a repeated section. It is used alongside start repeat lines, which show the start of a repeated section.

End/Start repeat

This line combines the start repeat and end repeat barlines, with either two single barlines with a single shared thick barline in the middle, or two thick barlines and no single barlines. On either side, there are either two or four repeat dots. It is used when a repeated section is immediately followed by another, separate repeated section.