Defining frame constraints

You can lock/unlock constraints on each side of frames independently; for example, if you want to unlock the bottom constraint only for frames that you want to have a fixed height.

Prerequisite

  • The left zone is shown.

  • Frames Frames button is selected in the Engrave toolbox.

  • If you want to define the constraints of frames on a page template, you have opened the page template in the page template editor.

Procedure

  1. In Engrave mode, select the frame whose constraints you want to define.
    Note

    You can only define constraints for a single frame at a time.

  2. In the Constraints section of the Frames panel, click the constraints that correspond to the sides of the frame that you want to lock/unlock.
    Figure 1. Locked constraint
    Figure 2. Unlocked constraint
    Note

    Frames must have at least one locked constraint from each pair of top/bottom and right/left, such as top and right.

Result

The constraints of the selected frame are changed. This affects which edges are locked to the corresponding page margin and whether the size and/or shape of the frame is changed on pages with different page sizes, orientations, and/or page margins. For example, frames with an unlocked top or bottom constraint have a fixed height. Similarly, frames with an unlocked right or left constraint have a fixed width.

After Completing This Task

You can change the size and/or shape of frames.