Playback Options for dynamics

You can change settings for how dynamics are interpreted in playback by making adjustments to the scale of the graphical curve on the Dynamics page in Playback Options.

You can open Playback Options in any of the following ways:

  • Press Ctrl/Cmd-Shift-P in any mode.

  • Choose Play > Playback Options in Play mode.

You can then click Dynamics in the page list on the left of the dialog.

Dynamic Curve

The graph at the top of the Dynamics page in Playback Options maps a continuous curve. This curve determines how the volume of dynamics increases across the range to .

A dynamic curve power of 1 creates a straight line, producing a steady dynamic increase. The difference between and is the same as between and .

A dynamic curve power higher than 2 creates a curved line, producing a faster dynamic increase in the middle of the range. The difference between and is much smaller than the difference between and .

The higher the dynamic curve power, the greater the contrast between dynamics in the middle of the range, and the smaller the contrast between dynamics at the ends of the range.

If your project uses a wide range of dynamics, including dynamics such as and , you might want a lower curve power with larger differences between the extremes of the range.

If your project has a smaller range of dynamics, such as a minimum of to a maximum of , you might prefer a higher curve power, so the differences between the dynamics in the middle of the range are more discernible.


Changing the dynamic curve affects the playback of all instruments in the project.

Note Dynamics

In the Note Dynamics section of the Dynamics page, you can set how much the volume of notes in playback is affected by stresses and articulation marks.


Humanize allows dynamics to vary randomly by the degree you set to mimic the natural fluctuations in a live performance.