Changing the project-wide position of hairpins relative to barlines
You can change whether all hairpins cross barlines when they end on the first note in the next bar project-wide. You can also change the minimum distance before hairpins are allowed to extend beyond barlines.
Procedure
- Press Ctrl/Cmd-Shift-E to open Engraving Options.
- Click Dynamics in the page list.
- In the Gradual Dynamics section, click Advanced Options.
-
Choose one of the following options for Hairpins ending at beginning of note at start of bar:
-
Do not cross barline
-
Allow to cross barline
-
- Optional: In the Horizontal Position section, change the value for Minimum distance to right of barline to allow dynamic to cross barline.
- Click Apply, then Close.