Changing the thickness of slurs

You can change the thickness of individual slurs, independently of your project-wide settings. You can also change the thickness of the middle of slurs independently of the ends of slurs.

Procedure

  1. In Engrave mode, select the slurs whose thickness you want to change.
  2. In the Properties panel, activate the following properties, individually or together, in the Slurs group:

    • End thickness

    • Middle thickness

  3. Change the values in the value fields in any of the following ways:

    • Enter values into the value fields.

    • Click the arrows beside the value fields.

Result

Increasing the values makes the corresponding part of the selected slurs thicker, decreasing the values makes the corresponding part of the selected slurs thinner.

Tip

  • Deactivating the properties returns the corresponding part of the selected slurs to their default thickness.

  • You can change the default thickness of all slurs project-wide on the Slurs page in Engrave > Engraving Options.