Changing the appearance of multi-bar rests at the end of flows project-wide

You can change the appearance of multi-bar rests that extend to the end of flows in all layouts project-wide. By default, multi-bar rests that extend to the end of flows show tacet al fine above the staff instead of the total bar count.

Procedure

  1. In Engrave mode, choose Engrave > Engraving Options.

    The Engraving Options dialog opens.

  2. Click Rests in the page list.
  3. In the Multi-bar Rests section, choose one of the following options for Multi-bar rests that extend to the end of the flow:

    • Show tacet al fine

    • Show bar count

  4. Click Apply, then Close.