Lengthening/Shortening repeat ending hooks
You can lengthen/shorten the hooks in repeat endings individually, independently of your project-wide settings.
Note
You cannot change the hook length of an individual segment in a repeat ending. Changing the hook length affects the whole repeat ending.
Procedure
- In Engrave mode, select the repeat endings whose hooks you want to lengthen/shorten.
- In the Properties panel, activate Hook length in the Repeat Endings group.
-
Change the value in the value field in any of the following ways:
-
Enter a value into the value field.
-
Click the arrows beside the value field.
-
Result
Increasing the value makes repeat ending hooks longer. Decreasing the value makes repeat ending hooks shorter.
Tip
You can change the default length of all repeat ending hooks project-wide on the Repeat Endings page in .