You can change whether all hairpins cross barlines when they end on the first note in the next bar project-wide. You can also change the minimum distance before hairpins are allowed to extend beyond barlines.
Procedure
-
In Engrave mode, choose .
The Engraving Options dialog opens.
-
Click Dynamics in the page list.
-
In the Gradual Dynamics section, click Advanced Options.
-
Choose one of the following options for Hairpins ending at beginning of note at start of bar:
-
Do not cross barline
-
Allow to cross barline
-
Optional: In the Horizontal Position section, change the value for Minimum distance to right of barline to allow dynamic to cross barline in any of the following ways:
-
Click Apply, then Close.