Per-flow notation options for barlines

You can set the appearance of barlines in each flow in your project independently on the Barlines page in Engraving Options.

On the Barlines page, you can change which barline is shown by default at the end of each flow, and choose whether barlines join all staves at the end of each system and at the end of the final system in a flow.

You can open Notation Options in any of the following ways:

• Press Ctrl/Cmd-Shift-N in any mode.

• Choose Write > Notation Options in Write mode.

• Choose Setup > Notation Options in Setup mode.

• Click Notation Options on the right of the Flows panel in Setup mode.

  

You can then select Barlines from the Category menu.