StudioChorus

StudioChorus is a two-stage chorus effect that adds short delays to the signal and modulates the pitch of the delayed signals to produce a doubling effect. The two separate stages of chorus modulation are independent and are processed serially (cascaded).



Delay

Affects the frequency range of the modulation sweep by adjusting the initial delay time.

Width

Sets the depth of the chorus effect. Higher settings produce a more pronounced effect.

Spatial

Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.

Mix

Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.

Rate

If Tempo Sync is activated, Rate allows you to specify the base note value for synchronizing the modulation sweep to the tempo of the host application (1/1 to 1/32, straight, triplet, or dotted).

If Tempo Sync is deactivated, the sweep rate can be set freely with the Rate dial.

Sync

Activates/Deactivates tempo sync.

Waveform Shape

Allows you to select the modulation waveform, altering the character of the chorus sweep. A sine and a triangle waveform are available.

Lo Filter/Hi Filter

Allow you to roll off low and high frequencies of the effect signal.

Note

This plug-in supports external side-chaining. You can use the side-chain input to control the modulation from another signal source. If the side-chain signal exceeds the threshold, the modulation is controlled by the side-chain signal’s envelope. For a description of how to set up side-chain routing, see the “Operation Manual”.