Audio Track Inspector
The Inspector for audio tracks contains controls and parameters that allow you to edit your audio track.
The top section of the audio track Inspector contains the following basic track settings:
- Track name
-
Click once to show/hide the basic track settings section. Double-click to rename the track.
- Edit
-
Opens the Channel Settings window for the track.
- Mute
-
Mutes the track.
- Solo
-
Solos the track.
- Read Automation
-
Allows you to read track automation.
- Write Automation
-
Allows you to write track automation.
- Open Device Panels (Cubase Pro only)
-
Allows you to create a device panel for the plug-in and device parameters of your track.
- Auto Fades Settings
-
Opens a dialog where you can make separate audio fade settings for the track.
- Record enable
-
Activates the track for recording.
- Monitor
-
Routes incoming signals to the selected output.
- Toggle Time Base
-
Switches between musical (tempo-related) and linear (time-related) time base for the track.
- Lock
-
Disables all editing of all events on the track.
- Show Lanes
-
Divides the tracks in lanes.
- Freeze Audio Channel
-
Allows you to freeze the audio channel.
- Volume
-
Allows you to adjust the level for the track.
- Pan
-
Allows you to adjust the panning of the track.
- Delay
-
Allows you to adjust the playback timing of the track.
- Load/Save/Reload Track Preset
-
Loads or saves a track preset or reverts the default presets.
- Input Routing
-
Allows you to specify the input bus for the track.
- Output Routing
-
Allows you to specify the output bus for the track.
Audio Track Inspector sections
Apart from the basic track settings that are always shown, audio tracks provide other Inspector sections. These are described in the following sections.
TrackVersions
Allows you to create and edit TrackVersions.
Chords Section
Allows you to specify how the track follows the chord track.
Inserts Section
Allows you to add insert effects to the track.
Strip Section
Allows you to set up the channel strip modules.
Equalizers Section
Allows you to adjust the EQs for the track. You can have up to four bands of EQ for each track.
Sends Section
Allows you to route the track to one or several FX channels.
Cue Sends Section (Cubase Pro only)
Allows you to route cue mixes to Control Room cues.
Direct Routing Section
Allows you to set up direct routing.
Surround Pan Section (Cubase Pro only)
Shows the MultiPanner for a track (if used).
Fader Section
Shows a duplicate of the corresponding MixConsole channel.
Notepad Section
Allows you to enter notes about the track.
Device Panel Section (Cubase Pro only)
Allows you to display and use device panels.
Quick Controls Section
Allows you to configure quick controls to use remote devices, for example.